Marked Turnstile Medium Size (Marked Turnstile with Lever) 2sets : Kobo-Nanarokuni Finished product set 1:80(HO) 1052
Pre-painted 1/80HO) by Kobo NANA ROKUNI, human height is about 2cm size
Full-scratch structure by "Kobo Nanarokuni"
Turnstile with sign Medium size (Turnstile with lever sign) Set of 2
Size: approx. W 23.5 x D17 x H 81.5 mm
Note: The lever is fixed and not movable.
Note: The lever is fixed and not movable. Note: The wiring has been pre-wired to ensure that the LED's are lit, however, it is necessary to disconnect the wiring with a soldering iron and re-wire it after installation.
Note: It is necessary to drill a hole of 1 to 1.5mm diameter in the installation site.
Note:The colour tone of the image may vary from the actual product due to your monitor and settings.
Information edited by Sakatsu Gallery
Manual points, of which there are now very few.
This is a model of the "switching device with signalling", equipped with a signalling sign and a lever to switch the point, which has been painstakingly produced by the workshop Einarokuni.
This is the first model of this type to be made from scratch.
The LED is built into a cylinder of about 2 mm diameter, which lights up the signal and rotates the sign.
With a separate power supply of 3 to 12 V DC, four signals can be lit, two blue and two yellow.
This model is reproduced as a medium-sized aircraft at a scale of 1/80, and can be recommended as a large aircraft at 1/87.
Note: The lever is fixed and not movable.
Note: The lever is fixed and not movable. Note: The wiring has been pre-wired to ensure that the LED's are lit, however, it is necessary to disconnect the wiring with a soldering iron and re-wire it after installation.
Note: It is necessary to drill a hole of 1 to 1.5mm diameter in the installation site.
Full-scratch structure by "Kobo Nanarokuni"
Turnstile with sign Medium size (Turnstile with lever sign) Set of 2
Size: approx. W 23.5 x D17 x H 81.5 mm
Note: The lever is fixed and not movable.
Note: The lever is fixed and not movable. Note: The wiring has been pre-wired to ensure that the LED's are lit, however, it is necessary to disconnect the wiring with a soldering iron and re-wire it after installation.
Note: It is necessary to drill a hole of 1 to 1.5mm diameter in the installation site.
Note:The colour tone of the image may vary from the actual product due to your monitor and settings.
Information edited by Sakatsu Gallery
Manual points, of which there are now very few.
This is a model of the "switching device with signalling", equipped with a signalling sign and a lever to switch the point, which has been painstakingly produced by the workshop Einarokuni.
This is the first model of this type to be made from scratch.
The LED is built into a cylinder of about 2 mm diameter, which lights up the signal and rotates the sign.
With a separate power supply of 3 to 12 V DC, four signals can be lit, two blue and two yellow.
This model is reproduced as a medium-sized aircraft at a scale of 1/80, and can be recommended as a large aircraft at 1/87.
Note: The lever is fixed and not movable.
Note: The lever is fixed and not movable. Note: The wiring has been pre-wired to ensure that the LED's are lit, however, it is necessary to disconnect the wiring with a soldering iron and re-wire it after installation.
Note: It is necessary to drill a hole of 1 to 1.5mm diameter in the installation site.
