1:80 JNR Type Arm Signal (Departure) : Kobo-Nanarokuni Finished product 1:80(HO) 1044
Pre-painted 1/80HO) by Kobo NANA ROKUNI, human height is about 2cm size
Studio Einarokuni's full-sculptures
. Size: approx. W 24 x D17 x H 81.5 mm
The LEDs are CRD controlled. The LEDs are CRD-controlled and require a separate power supply of between 3 and 12 V DC to light up.
Drilling of approx. 2.5mm diameter is required for installation.
Note:The deadweight rod is not movable.
Note:The colour tone of the images may vary from the actual product due to your monitor model and settings.
Information edited by Sakatsu Gallery
This is a full-scratch work of a common arm-tree departure signal, widely seen in the former Japanese National Railways after the war.
The body is made of brass soldered by the craftsmanship of the workshop Ena Rokuni.
The ladder section is cut from western white board and the treads (steps) are cut out one by one and finished.
What's not there, we make!
The ladder is cut from western white board and the steps are cut out one by one.
If you have a power supply of 3 to 12 VDC, the red light will be lit by the built-in light bulb LED and lens.
�@Note:The deadweight rod is not movable.
Note:The colour tone of the images may vary from the actual product due to your monitor model and settings.
Studio Einarokuni's full-sculptures
. Size: approx. W 24 x D17 x H 81.5 mm
The LEDs are CRD controlled. The LEDs are CRD-controlled and require a separate power supply of between 3 and 12 V DC to light up.
Drilling of approx. 2.5mm diameter is required for installation.
Note:The deadweight rod is not movable.
Note:The colour tone of the images may vary from the actual product due to your monitor model and settings.
Information edited by Sakatsu Gallery
This is a full-scratch work of a common arm-tree departure signal, widely seen in the former Japanese National Railways after the war.
The body is made of brass soldered by the craftsmanship of the workshop Ena Rokuni.
The ladder section is cut from western white board and the treads (steps) are cut out one by one and finished.
What's not there, we make!
The ladder is cut from western white board and the steps are cut out one by one.
If you have a power supply of 3 to 12 VDC, the red light will be lit by the built-in light bulb LED and lens.
�@Note:The deadweight rod is not movable.
Note:The colour tone of the images may vary from the actual product due to your monitor model and settings.
